Login: root Password: root (Note: On modern TNL/MTN nodes, the default user is often root and the password is root . On older TN nodes, it might be admin / admin .)
By default, you are dropped into Read-Only mode. To make changes, you must switch to Configuration Mode.
configure You will notice the prompt changes, often indicating you are now in the configuration tree. Before configuring a link, it is vital to check the health of the hardware. These commands are your "go-to" tools for daily maintenance. Checking the Node Status To see a summary of the node, including serial number, software version, and uptime: Ericsson Mini Link Cli Commands
get sw
get inventory The most critical command for a field engineer. This lists active alarms on the node. Login: root Password: root (Note: On modern TNL/MTN
Once the connection is established, you are greeted with a login prompt.
Ericsson MINI-LINK microwave transmission systems are the backbone of mobile backhaul networks worldwide. From the legacy TN (Traffic Node) series to the modern TN and CN (Craft Node) platforms, these devices are renowned for their reliability and spectral efficiency. However, to unlock their full potential and maintain network stability, engineers must master the Command Line Interface (CLI). configure You will notice the prompt changes, often
get node If you need to verify the ID Unit (IDU) or Outdoor Unit (ODU) serial numbers for inventory management:
get alarms Output Interpretation: Look for "Radio Signal Degrade" or "Loss of Signal" (LOS) for link issues, or "Ethernet Link Down" for cabling problems. To ensure compatibility between IDU and ODU, or to verify an upgrade: